Full HVAC and Water Heater System Install in Ypsilanti

This was a full system replacement - furnace, air conditioner, and water heater all in one job. That's not something we do every day, but when a home needs it, there's no better time to get everything done right at once. The homeowner gets fresh, reliable equipment across the board and doesn't have to worry about staggering costs or scheduling multiple contractors down the road.

We went with Bryant for both the furnace and the AC. Bryant is a brand we trust - the equipment is built well, the warranties are solid, and it holds up in Michigan winters. The new furnace is a high-efficiency two-stage unit with PVC flue piping, which means more heat from every cubic foot of gas burned. Less waste, lower utility bills, and consistent comfort throughout the house.

The outdoor Bryant condenser is sitting on a pad and ready to go. A properly sized and matched system like this one - where the furnace and AC are designed to work together - runs more efficiently than mixing and matching equipment. It's a detail that matters a lot when you're talking about long-term performance and energy costs.

For the water heater, we installed a State ProLine XE - a power-vent commercial-grade unit. This isn't a basic builder-grade tank. It's built to handle demand and has the power-vent setup to exhaust safely even without a traditional chimney flue. Clean installation, properly piped, and ready to last.

Jobs like this one are exactly what we do at Comfort Mechanical Heating and Cooling. Whether it's a furnace installation, an AC replacement, or a water heater swap, we handle it with the same care and attention to detail - fair pricing, quality equipment, no shortcuts.